Error code
Bosch error code E:30 / -80
Bosch error code E:30 / -80: water cannot get out through the drain hose or the standpipe. What the code covers, what to check first, and what it does not tell you — on washers.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
What we can confirm
Code E:30 / -80, from the manufacturer's own pages
A code is only meaningful together with the generation showing it — the same two digits mean different things across generations.
The code
E:30 / -80
Water cannot get out through the drain hose or the standpipe
or call (305) 783-3552
What it narrows down to
Drain path restricted
What you are probably seeing
Diagnostic
From $95, credited to the repair
What it looks like from the kitchen
The symptom this code usually arrives with
A code names the subsystem; the symptom is what sent you to look at the display in the first place. That page says what it usually turns out to be, cheapest cause first.
-
There is a filter you can open Washer not draining
A cycle that stops with water in the drum, or clothes left soaking because the machine never got to the spin. There is a pump filter behind a flap at the front of these machines, and almost nobody knows it is there.
- Cycle stops with water in the drum
- Will not spin because it has not drained
- A code beginning E:30 or E:36
In more detail
About Bosch error code E:30 / -80
What this one means
Water cannot get out through the drain hose or the standpipe. It is a code the manufacturer publishes for this appliance, not one we have worked out — and it is decoded here rather than left as three characters on a display.
The other ways your machine may say it
The same condition is published under more than one label, because it has been carried across generations of this appliance:
- E:30 / -80, E:36 -10 — the same condition, on machines of different ages
What the code covers
A published cause names a circuit rather than a component, which is the single most useful thing to know before ordering a part. This one covers:
- A kinked or blocked outlet hose
- A hose pushed too far down the standpipe
- An unsuitable extension on the outlet
What to try yourself
- Straighten the outlet hose behind the machine — easy to kink on a stacked pair
- Check the hose is no higher than the manufacturer allows
- Check how far it goes into the standpipe
Then what
This is the code that most often turns out to be installation rather than appliance, and on a stacked pair in a closet it is the first thing worth looking at.
This code is published for washers. The full list of codes has the rest of them, searchable, including the labels older and newer machines use for the same conditions.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards